International Nomenclature of Cosmetic Ingredients (INCI):
This product does not need to be listed on the product ingredient label.
Common Name Ingredient Listing (FDA Approved):
This product does not need to be listed on the product ingredient label.
Directions:
Melt & Pour Soap: Pour melted soap at a temperature no hotter than 135ºF into mold. Cool until soap has hardened. Remove soap from mold, and slice into bars. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.
Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Slice into bars. Allow soap to cure for 4-8 weeks. Note that some cp soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.
Lotion Bars: Pour melted lotion bar mixture into mold at a temperature no hotter than 135ºF. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold. Slice into lotion bars.
Care:
Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.
| Average Customer Rating: |
 |
(3 Reviews) |
|
Nora • Arizona
Date Submitted: 04/26/2016
I Recommend This Product!
|
|
"Love it!!" |
|
COMMENTS: Good quality mold, I like that I can keep my bar soaps in the size of 4 oz. And everyone love the detailed the words Lavender on the bar soap look like.
|
|
PRODUCT USED IN: Soap - Melt & Pour
|
|
|
|
|
Rachelle • Colorado
Date Submitted: 09/21/2015
I Recommend This Product!
|
 |
"Cute!" |
|
COMMENTS: These bars are cute enough, but I was hoping they were a bit wider. They are only 2 inches. I should have seen that, but was in a hurry when I ordered and didn't read the exact measurements. I only read the final bar weight, which is decent. They are long enough and deep enough top to bottom, but they are fairly thin. It does give them a different look and people at the craft show bought a good number of them, so maybe being only 2 inches wide doesn't matter in the long run since they are cute.
|
|
PRODUCT USED IN: Soap - Cold Process
|
| THINGS I LIKE |
|
THINGS I'D LIKE TO CHANGE |
• the wording on the soap
|
|
• maybe add 1/4th to 1/2 inch in width
|
|
|
|
Taniece • Florida
Date Submitted: 04/27/2014
I Recommend This Product!
|
|
"Lavender soap mold" |
|
COMMENTS: Will purchase another!
|
|
PRODUCT USED IN: Soap - Melt & Pour
|
|
|
|
| Question + Answer. Here you can ask or answer questions All questions are queued and answered quickly during business hrs. You can also answer questions posted by other customers if you have valuable information. |
 |
0 Question(s) Shown Below |
| Distributor & Drop Shipper Minimum Advertised Pricing |
As a Crafter’s Choice Distributor and/or Drop Shipper you have agreed to abide by the following Minimum Advertised Price (MAP) for each product and price level. You are permitted to advertise products at a higher price. You may not advertise the products at a lower price. Below you will find the MAP for this product.
|
