International Nomenclature of Cosmetic Ingredients (INCI):
This product does not need to be listed on the product ingredient label.
Common Name Ingredient Listing (FDA Approved):
This product does not need to be listed on the product ingredient label.
Directions:
Melt & Pour Soap: Pour melted soap at a temperature no hotter than 135ºF into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.
Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.
Lotion Bars: Pour melted lotion bar mixture into mold cavities at a temperature no hotter than 135ºF. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold.
Care:
Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.
| Average Customer Rating: |
 |
(2 Reviews) |
|
Ashley • Illinois
Date Submitted: 06/24/2019
I Recommend This Product!
|
 |
"Easy to use" |
|
COMMENTS: This mold was very easy to use and looks very realistic to real watermelon. The only issue I had was the very thin first line, where the green rind goes. It could be thicker, in my opinion
|
|
PRODUCT USED IN: Soap - Melt & Pour
|
|
|
|
|
Leta • New York
Date Submitted: 07/01/2017
|
 |
"Good sturdy mold. " |
|
COMMENTS: Just a personal prefference but I'd like to have the white and green parts of the watermelin. The green strip just doesn't look quite right to me. The mold is great otherwise and I like just making 1 soap and being able to cut it into slices! Removal is much easier than single cavity plastic molds as well.
|
|
PRODUCT USED IN: Soap - Melt & Pour
|
|
|
|
| Question + Answer. Here you can ask or answer questions All questions are queued and answered quickly during business hrs. You can also answer questions posted by other customers if you have valuable information. |
 |
0 Question(s) Shown Below |
| Distributor & Drop Shipper Minimum Advertised Pricing |
As a Crafter’s Choice Distributor and/or Drop Shipper you have agreed to abide by the following Minimum Advertised Price (MAP) for each product and price level. You are permitted to advertise products at a higher price. You may not advertise the products at a lower price. Below you will find the MAP for this product.
|
